New grouting
Grout systems for newly laid tiles in homes, offices, shops and hotels.
Prima Grout & Tile Solutions Sdn Bhd focuses on two trades: grout systems and tile installation. Every job follows the same method, from the first inspection to handover.
When grout fails, water gets in, stains set and tiles start to loosen. We install new grout systems and restore old ones, for homes and commercial spaces.
Grout systems for newly laid tiles in homes, offices, shops and hotels.
Stained, cracked or crumbling grout is raked out and replaced. Your tiles stay, the joints are renewed.
Bathrooms, kitchens, balconies and pool decks, finished with systems made to resist water and mould.
Grout colours weighed out to a saved formula, to suit your tile or match an existing shade.
The difference between grout that lasts and grout that fails is mostly preparation. These are the steps we do not skip.
Tiles are tapped for hollow spots and joints checked for cracks, gaps and moisture before we quote a system.
Old grout is raked out along the full joint and the dust is cleared, so new grout bonds to clean, sound edges.
Polyurea, hydrogenated epoxy or organosilicon, chosen by room: wet or dry, indoor or outdoor, foot traffic and sunlight.
Custom pigments are weighed on a digital scale against a saved formula, so a later batch matches the first.
Joints are filled full, then tooled to one consistent profile. Excess is cleaned off the tile face before it cures.
You are told how long to keep the area dry and off-limits, and how to clean it afterwards.
We set out, lay and level floor and wall tiles, then grout them with the same systems and standards our grouting work is known for. One team, one standard, from bare floor to finished joint.
Homes, showrooms and commercial spaces, from standard sizes to large-format tiles.
Big tiles need a flat base, full adhesive contact and careful handling. We plan for all three.
Hollow or cracked tiles are lifted and re-laid on a sound bed, and the joints regrouted to match.
Tiled with the right fall to the floor trap and clean cuts around every fitting.
Most tile problems, like hollow spots, uneven edges and cracked corners, are decided before the first tile goes down.
The floor or wall is checked for level, soundness and moisture first. Hollow areas are found by tapping.
The layout is planned from the room's centre lines, so edge cuts are even and joints line up through doorways.
Notched trowel on the base and back-buttering on large tiles, to avoid voids that later sound hollow or crack.
Tile levelling clips hold neighbouring edges flush while the adhesive sets.
Left at the perimeter and across large areas, so tiles have room to move with Malaysian heat and humidity.
Floor traps, pipes and fittings are cut around precisely, not patched with grout.
Finished with the same grout systems and colour matching as our grouting projects.
Grout systems are not interchangeable. Performance changes with humidity, traffic and sunlight, so the material is chosen for the room.

Made for Malaysia's hot, humid climate: anti-mould, waterproof and weather-resistant, developed with local conditions in mind.
“Grout systems are not interchangeable. Performance varies across humidity, traffic and environmental conditions. We chose CUALI® because, held to the same standard, it performs above many others.”
PRIMA is our own brand and our main grout, made for Malaysia’s climate. CUALI® is our partner brand, and we also use its products. CUALI® products are trusted across more than 1,800 service points worldwide and supported by certifications including France Indoor Air A+, FDA, CE and the China Environmental Label.

New-generation premium organosilicon grout for indoor and outdoor use. Contact us for more details.
Technical Data Sheet ref. CGQC-A-313. Tested to GB/T national standards.

Pure hydrogenated 5-in-1 epoxy tile grout, developed for appearance, durability and long-term protection.

The base layer behind a lasting surface. It raises tile adhesion strength and reduces long-term hollowing, detachment and movement cracks.
We work across Malaysia. These are the regions where our founding team and Prima have completed projects.
Not covered here? Ask us on WhatsApp.
Usually not. If the tiles are sound, we rake out the old grout and regrout. If some tiles are hollow or cracked, we will show you which ones and recommend re-laying them.
It depends on the room. Wet areas, outdoor areas and busy floors each need different properties. We recommend a system after seeing the site, and explain why.
Curing time depends on the grout system and the conditions on the day. Before we start, we tell you how long to keep the area dry and off-limits.
Yes. We have completed projects in all four regions, including Penang, Ipoh, Johor Bahru, Muar, Melaka, Seremban and Pahang.
Yes. Tiling is now a core Prima service, so one team can lay the tiles and finish the joints to the same standard.
Contact us directly on WhatsApp, by phone or by email, and we will follow up with you on pricing.
Send a few photos on WhatsApp. We will tell you what we see and what it would take to fix it properly.